Cisco VM-FEX Introduction Part 2

Posted on December 30, 2011 by Colin Lynch
Unknown's avatar

About Colin Lynch

Technical Architect and Data Center Subject Matter Expert. I do not work or speak for Cisco or any other vendor.
This entry was posted in VM-FEX and tagged , , , , , , , , , . Bookmark the permalink.

3 Responses to Cisco VM-FEX Introduction Part 2

  1. Ramnath's avatar Ramnath says:
    October 17, 2013 at 3:52 am

    VM-FEX is physical component or it’s Software component

    Reply
    • Colin Lynch's avatar ucsguru says:
      October 17, 2013 at 9:13 am

      Hi Ramnath
      There is no specific hardware or software you need to buy to enable VM-FEX on Cisco UCS, over and above standard Cisco UCS Hardware (FI & VIC1240,VIC1280 or M81KR) There is also no licensing requirement.

      Regards
      Colin

      Reply
  2. B Guha's avatar B Guha says:
    September 19, 2014 at 12:15 pm

    Very useful videos. Thanks. Is it still the case (latest release of UCS, vNIC, and vSphere 5.5U2) with VM FEX (HP mode) that it is best implemented using dvSwitch on the vSphere side as you have described in the video?

    Reply

Leave a reply to B Guha Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.